My unfinished mod of cold steel rifleman's hawk

Discussion in 'Other Skills' started by Todd Ziegler, Jul 18, 2018.

  1. Todd Ziegler

    Todd Ziegler Tracker

    Blog Posts:
    0
    Joined:
    Nov 2, 2017
    Messages:
    88
    Likes Received:
    160
    Location:
    Tipton, IN
    Any suggestions for what I should do next or not, would be appreciated The head is not set, so I can remove it easily. I can easily polish it up again if I get any good ideas. Other than the flame I can't think of anything or should I stop.
     

    Attached Files:

  2. PAcanis

    PAcanis Supporter Supporter

    Blog Posts:
    0
    Joined:
    Sep 17, 2017
    Messages:
    3,721
    Likes Received:
    17,092
    Location:
    Pennsylvania
    Cool flame.
    I didn't realize these could be polished up like that. Nice polishing job.
     
  3. Todd Ziegler

    Todd Ziegler Tracker

    Blog Posts:
    0
    Joined:
    Nov 2, 2017
    Messages:
    88
    Likes Received:
    160
    Location:
    Tipton, IN
    I am terrible at drawing and finding a cheap vinyl flame was the hardest part.
     
  4. Todd Ziegler

    Todd Ziegler Tracker

    Blog Posts:
    0
    Joined:
    Nov 2, 2017
    Messages:
    88
    Likes Received:
    160
    Location:
    Tipton, IN
    I am going to delete this post because I posted it twice.
     
  5. PAcanis

    PAcanis Supporter Supporter

    Blog Posts:
    0
    Joined:
    Sep 17, 2017
    Messages:
    3,721
    Likes Received:
    17,092
    Location:
    Pennsylvania
    This post has the pic.
    Unless you edited your other thread...
     

Share This Page